The only thing that may require special tooling would be a puller for the pump housing.Take a measurement from the face of the pump housing to the edge of the trans mount face and be sure that the pump is at that same depth on reassemble,that is if you are putting all new guts.I put a high ratio gear set in and I remember that being a factor.
__________________
92LX 5.0 Hatch,4.10 gears Auburn Pro,Mosser axels,alum drive shaft AOD hi ratio gear set,3200 stall TCI conv,Bassani long tube headers/cats,2 chamber flow masters,2.5inch exhaust,331 stroker,alum GT40 heads ported,Omega 1.7 roller rockers,JE forged pistons,Eagle rods,E cam,GT40 upper/lower intake,70mm mass,73mm Pro M bullet,MSD ignition,Cartech fuel sys w/external Aeromotive fuel pump,30lb injectors,Vortech S trim,Tubular front end,D&D coil overs up front
|