MustangWorks.com : Ford Forums - View Single Post - 95 Mustang GT

Aaeros · 01-17-2006, 07:24 AM

Back when my problem first started, I took the Ignition Control Module (ICM) to O'riley Auto Parts and had them test it. There are 3 checks that the machine runs. The first one, Low Range, tested bad and the other two were ok.

I bought the borg/warner (lifetime warranty) ICM. I have no clue what might be zapping it, if indeed this latest one I installed is bad.

As far codes from the key ignition, there are some steps to get engine failure codes. I dont have the exact steps, and that's what I was asking here. Apparently you jumper something, turn the ignition on and off 3 times or so, then the check engine light will blink giving the 2 digit failure code. (I dont have an ODB reader)

01-17-2006, 07:24 AM	#7
Aaeros Registered Member Join Date: Jan 2006 Posts: 9	Re: 95 Mustang GT - Starting Problems Back when my problem first started, I took the Ignition Control Module (ICM) to O'riley Auto Parts and had them test it. There are 3 checks that the machine runs. The first one, Low Range, tested bad and the other two were ok. I bought the borg/warner (lifetime warranty) ICM. I have no clue what might be zapping it, if indeed this latest one I installed is bad. As far codes from the key ignition, there are some steps to get engine failure codes. I dont have the exact steps, and that's what I was asking here. Apparently you jumper something, turn the ignition on and off 3 times or so, then the check engine light will blink giving the 2 digit failure code. (I dont have an ODB reader)