Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-18-2001, 02:22 PM
|
#1 |
|
Registered Member
Join Date: Jan 2001
Location: virginia beach
Posts: 43
|
estimated 1/4 mi time
I own a 96 GT with the following mods.
2.5" flowmaster cat back 2.5" MAC hpipe with cats 70MM throttle body Adjustable fuel pressure regulator(at 42 PSI) 87 Prom bullet MAM ripper shifter 3.73 gears underdrive pulleys hypertech power programmer 3 with thermostat(160) MAC cold air induction Steeda timing adjuster Will the car run faster with the installed h-pipe with cats or an offroad h-pipe. Both from MAC and 2.5", I own both. What degrees should I have the timing adjusted to. Where is the best place to get your cat dynoed and run the 1/4 at in Va? |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| My report from racing at the NMRA event in Bowling Green (was ATTN: Lt. Dan) | andy669 | Racer's Club House | 12 | 10-08-2003 02:41 PM |
| estimated 1/4 time?? | sn95gt19 | Modular Madness | 5 | 12-03-2002 06:08 PM |
| Towed away this time! (Long) | 1988GTCONERTIBLE | Windsor Power | 6 | 10-26-2001 06:05 PM |