Mustang92
03-29-2001, 12:16 AM
Since I had some problems with my clutch slipping at Bradenton I replaced it with a Centerforce Dual Friction disk and FRPP Heavy Duty Pressure plate. Also picked up a lift off hood in Bradenton that I had painted this past weekend. It dropped about 20lbs off the front of the car. Anyways I only had two passes tonight since I got there so late but my best pass of the night was a 12.91@101.93 with a 1.74 short time. Not sure what was happening with the MPH the traps seemed to be slightly off. On my previous pass I went 103.32 right off the freeway.
My short times were pretty bad because I had to remove my Aluminum LCA's. They were for a 96 Cobra and had the wrong size bushings in them causing them to move under pressure and effectively tearing one of my torque boxes. So now I'm running stock LCA's with no quad shocks or sway bar (a big no no!), which of course caused major wheel hop on launch.
The clutch works perfect, grabs nice in all gears even 4th hits the tires hard. I figure once I put in my new LCA's and get my short times back into the usual 1.65-1.67 range I should be able to get into the 12.8x's.
Conditions tonight were pretty good 73* and 76% humidity...well at least as good as it gets in Florida.
------------------
00 GT, MAC Offroad H, Steeda Pulleys, Steeda Timing Adjuster, FMS 4.10’s, Flows w/turndowns, UPR shifter, UPR subframes, UPR LCA’s, Air Filter, Lakewood 70/30 & 50/50, Weld Pro Stars, Nitto DR’s, 253.8RWHP/292.8RWTQ
Best on DR's 13.09@103.92 (1.81 60ft)
Best on ET Drags 12.99@104.60 (1.67 60ft)
M/M 100
88 LX coupe X-FHP, 12pt Cage, UPR K-member, 31 spline rear, full spool…
My short times were pretty bad because I had to remove my Aluminum LCA's. They were for a 96 Cobra and had the wrong size bushings in them causing them to move under pressure and effectively tearing one of my torque boxes. So now I'm running stock LCA's with no quad shocks or sway bar (a big no no!), which of course caused major wheel hop on launch.
The clutch works perfect, grabs nice in all gears even 4th hits the tires hard. I figure once I put in my new LCA's and get my short times back into the usual 1.65-1.67 range I should be able to get into the 12.8x's.
Conditions tonight were pretty good 73* and 76% humidity...well at least as good as it gets in Florida.
------------------
00 GT, MAC Offroad H, Steeda Pulleys, Steeda Timing Adjuster, FMS 4.10’s, Flows w/turndowns, UPR shifter, UPR subframes, UPR LCA’s, Air Filter, Lakewood 70/30 & 50/50, Weld Pro Stars, Nitto DR’s, 253.8RWHP/292.8RWTQ
Best on DR's 13.09@103.92 (1.81 60ft)
Best on ET Drags 12.99@104.60 (1.67 60ft)
M/M 100
88 LX coupe X-FHP, 12pt Cage, UPR K-member, 31 spline rear, full spool…