Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-09-2002, 08:04 PM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Hampton, Virginia
Posts: 227
|
66 Conv. 289 to 351
Ok, I am getting near finally and I know I can put a 302 in place of the 289 but what would it take to put the 351W in their. I know the 351 has width of 1 1/4 inches wider on each side. Am I going to have a problem finding headers to fit in their or what. This is my first conversion and I understand the motor mounts and the C-4 will mount with no problems if I heard right. Any help would be much appreciated.
351W or 351C which would be better.
__________________
1980 RX7 with 289 Ford V-8 bored .030 over, Very radical cam, Torker 2 high rise intake, Holley 650 Carb, MSD Nascar 6ALN ignition, MSD coil and distributor, Headers with dual open side exhaust. Over 300 horse. 1966 Mustang still in progress |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lowering a Conv. GT anyone done this one? | Big Bopper | Windsor Power | 3 | 04-04-2002 11:02 AM |
| sn95 five lug conv for a fox | chatcher | Windsor Power | 1 | 03-09-2002 11:48 AM |
| Conv. gear ratio? | Big Bopper | Windsor Power | 4 | 03-01-2002 09:45 PM |
| Messing around with a C5 conv | AJSTANG | Stang Stories | 3 | 04-12-2001 09:23 AM |
| cobra conv. or just reg mass air conv. | terrible0ne | Windsor Power | 3 | 03-10-2001 08:14 PM |