Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-03-2002, 05:20 PM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Metairie, La. USA
Posts: 132
|
Blower motor
Should the blower motor for the a/c drop the voltmeter down alot when on full blast? With the a/c on and the fan on high, it drops the voltage down to below 12 and that is with the 3G alt.
__________________
Engine: 1990 5.8 / Edelbrock Performer set-up MSD ignition Suspension: Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors / Drivetrain: Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel / 5.8 in the hole |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to test the blower motor and resistor? | Bad89stang | Windsor Power | 5 | 12-03-2003 10:44 PM |
| A/C and blower motor question | Bad89stang | Windsor Power | 5 | 07-17-2003 02:38 PM |
| ADDING A BLOWER TO A CARB MOTOR? | Coupe Devil | Windsor Power | 19 | 08-29-2001 12:07 AM |
| Best blower motor? | 88cobraconvt | Windsor Power | 1 | 07-29-2001 07:15 PM |
| How do I change the heater blower motor? | Saleen308 | Windsor Power | 2 | 01-14-2001 10:17 AM |