Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-09-2002, 05:54 PM
|
#1 |
|
Registered Member
Join Date: Feb 2001
Location: Berkshire County - Massachusetts
Posts: 735
|
check out new pick and give me some advice
I am the type of guy that likes the lower look of cars. But my stang sits high in the front (as most do). I heard that the Lakewood drag shocks that I'm using are good for youe ET due to the weight transfer but I wouldn't no since I haven't taken her down the strip yet. If I was to try to lower the front end a little...would it hurt my potential E.T.?? And would I need to put struts back in to lower it?? Thanks
__________________
Red 1993 GT Street Machine Best E.T. - 12.41/Best MPH = 108 Engine is a 1969 351 block w/393 stroker kit. Dynamic Roller Myte C4, 8 pt cage. Edlebrock Performer heads and Victor Jr. EFI, FRPP 30lb injectors & Cartech fuel system. MSD ignition. Sothside Machine bars & Sub-frames, adj. upper's, 3.73's, Koni rear shocks, much more |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Helped a neighbor Sunday pick up a race car | StangFlyer | Blue Oval Lounge | 14 | 07-18-2003 08:29 PM |
| making some changes...need cam advice | Frankenstang65 | Classic Mustangs | 6 | 03-01-2003 09:18 AM |
| Planning Ahead. Need Advice on Next Rod to Build! | Mercury | Blue Oval Lounge | 13 | 07-06-2001 11:58 AM |