MIL question !!!

I would like to see if anyone has used the MIL where you have to cut the wire on the o2 senor ? This set you have to cut the 02 senor and wire these in. I have bought a set off of ebay and thought that I was getting the set that just clicks in ,,, but like most stuff on ebay thats not what came in. I hear this MIL work just as good as the click in kind but would like to see if anyone has tried them and how the install when !


thanks

[surfbeast]

My friend and I put his in in about one hour or less and everything went fine. Just make sure to use good quality tape around the connections. We used a shrink wrap tape that realy seals up good. He paid about $29 bucks for the set from the MIL website. I will be buying some soon, I wasn't aware they made a pair that just clicks in. I imagine they would be very costly because they would have to repace the sensors, I think? Anyway the directions are easy, if you have a problem check out the MIL eliminator website for step by step directions.

Good luck

[GITY UUP]

Dallas Mustang sells the MIL Eliminators that just click on in between your O2 sensors. They install in about 2 minutes. Also included are a pair of zip ties to tie the MIL eliminators up and awayfrom your exhaust system.

Originally posted by surfbeast

I wasn't aware they made a pair that just clicks in. I imagine they would be very costly because they would have to repace the sensors, I think?

Good luck [/B]

They sure do have the ones that clip in, they do not make you change any thing on your fac plugs. You just un-clip the fac plugs and the new MIL have a male and female ends and just clip both in to which end matched which. But like you said they do cost a little bit more , they start at 59.95 and go up to 80.00 bucks. But the good thing about them is the install and they are all ready weather proof. But i got took on ebay and will have to use the ones I have now , damit !!!!!!! But thanks for the info , at least now I know I can cut the o2 wires !!!!!!!