Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-15-2002, 07:28 AM
|
#1 |
|
Registered Member
Join Date: Nov 2001
Location: germantown MD
Posts: 283
|
Wiring Problem, need help
Ok last week I ran my car for the first time since it was back together. It overheated and I tore it down and straightened a warped head. Well I got it all back together and went to start it last night and there was no spark. It took me a few minute to figure out that the four wires coming out of my duraspark ignition module had been torn off. I couldn't remember how they hooked back up as some of the colors are faded. I think two of the wires went to the coil and two went to the distributor. Does this sound right. Does any one have any information about the wiring. Keep in mind this is a 4 bbl. 85
__________________
85 GT 4bbl roller cam 2 ch. Flowmasters, O/R H-pipe Performer intake and carb milodon water pump, FMS 9mm wires, aluminum driveshaft, king cobra clutch |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5.0 swap and wiring | surfsup | Windsor Power | 1 | 10-04-2004 11:24 AM |
| follow up to horrible vibration problem | Toeclicker | Windsor Power | 4 | 12-18-2003 06:38 PM |
| Please help stutering problem | Just me | Windsor Power | 10 | 10-18-2002 02:37 PM |
| Speedo/Tach Wiring Problem | gofishing | Classic Mustangs | 0 | 07-01-2002 09:48 AM |
| need help with wiring problem | 8d850 | Windsor Power | 2 | 06-14-2002 09:24 AM |