Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-06-2002, 01:27 PM
|
#1 |
|
Registered Member
Join Date: Jun 1999
Location: Walker, MI, USA
Posts: 1,202
|
About to Blow Up my car!!!!!!! Wont work Right!!!
Here is what it is doing NOW. Idels Fine when you give it gas MY Air/Fuel Metter goes off the chart Leans out!!!!!!! But it you nail it it runs fine.... here is what I have New on the car.
Both O2's IAC tested the ECU tested the MAP new Ait Tep sensor New TPS Diff Injectros Re-did all Grounds No Vac leaks AT ALL. Timming set to 12 Fuel Pressure is good. Next Might it be the O2's I have in stalled a Ait Fuel Gauge on them BOTH Cut and spliced the wire......... Might that be it making The O2's not work right.......ThX Guys/Gals for the help I need Info FAST as my Truck Tranny Died today!!!! I need to get the stang going FAST!!! today or in the moring PLEASE help me solve this!!!!!!!! Thx for every thing.
__________________
Engine: steel mounts, Under drive pulleys, K&N, GT-40 Intake ported Lower, No power steering, No A/C, Mac cold intake, 65MM TB, 255 Fuel pump, 24's, AFR 165 58cc, Rocker Arms 1.7with the stock Cam, 1 5/8 short headers, offRoad X-pipe Drive Train: 3.55, T-5 with a Pro 5.0 shifter 12.656@107.71MPH See It at www.T-racing.com/mustang.htm |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| will a 91 mass air harness work in a 88 gt? | bryan88gt | Windsor Power | 5 | 03-24-2002 12:39 AM |
| Anyone get ragged on at work for driving a Ford? | Crazy Horse GT | Blue Oval Lounge | 25 | 03-10-2002 07:26 PM |
| blow thru mass air meter? | PSI GUY | Windsor Power | 1 | 02-07-2002 09:16 AM |
| will this work for forced induction? | mikos chris | Windsor Power | 0 | 01-14-2001 03:05 PM |
| Need some professional advice - head work, valve springs, rockers, cam. pretty long. | AxemanZZ | Windsor Power | 15 | 01-11-2001 01:30 PM |