Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-09-2002, 03:09 PM
|
#1 |
|
Registered Member
Join Date: Jul 2002
Location: Pont Rouge, Quebec, Canada
Posts: 45
|
Milled heads and 347 CI swap
I ahve milled my edelbrock alu. head to have a reasonable
10:1 compression ratio with a 302 CI block. Is it possible to keep those heads if i stroke the engine to 347 CI? What will be the new compression ratio? (i am not too familiar with those calculations) Also what could be the typical gain with ported aluminium head, E303, and edelbrock RPM intake? Oh yes i have an other question in mind... Why is everybody choosing to install superchargers instead of stroking the 302? Superchargers are very popular compare to the 347 CI swap. If I had to choose i would take the 347 crank anytime. any advice is welcome, Regards, Sebastien Cote Last edited by eatsgmcar; 08-09-2002 at 03:19 PM.. |
|
|
|
|