pulling to one side when braking

[HKstang]

When I get on my brakes whether its really lightly or really hard, my steering wheel wants to pull to the left. If I hold the wheel lightly when coming to a stop and let go just as I let go of the brakes the steering wheel will turn slightly back to the right.

I just had an alignment done, it was doing this before the alignment too. My mechanic said there was a little play in my steering rack, would this be the reason?

Thanks,
Geoff

[toms89]

If it does it under braking its your brakes. Sounds like your front left is braking harder than the front right. I would check your brakes.

[Chevyguy]

Sounds like your pass side caliper is not working correctly. If your drivers side brake pads are more worn, or you notice more brake dust on the drivers side this confirms that. I had this same problem, I paid $13 a piece for rebuilt calipers at Auto Zone and they work fine now. Also a bad ball joint will cause the car to jerk to one side when you hit the brakes but then it goes straight, been there too.

------------------
Frank W
90 5.0 LX coupe Daily driver. Silencer removed, K&N filter. Flexalite fan, 3 core radiator. FMS flywheel and Clutch, FMS blue wires Energy Suspension end links
88 Notch 2.3L 5 speed Parts/beater car My two Notchbacks (http://picturecenter.kodak.com/share?invite=y8QgEr3w4PETJSxz75GUz7Mho580knQt)

74 Chevy Laguna Type S-3 305 Finally fixed getting a 454 to put in garage
<A HREF="http://www.chevellepages.com/folingo" TARGET=_blank>www.chevellepages.

[Fostang]

Mine tends to jerk to the right. When I'm about to take a look and replace the part it'll work fine. They're both new calipers and the wear is the same on both. Only thing is that sometimes the right tire will make a noise when I take off as if it were staying stuck.

------------------
67'fastback-Edelbrock carb,intake,cam,valve springs.Rhode lifters, CompCam rocker arms, windage tray,cerama coated headers,dual flows with H-pipe, modded c-4,tci stall converter,perma cool electric fan,aluminum water pump,griffen aluminum radiator,accel 8.8 cable,wide cap distriburator,magnetic pick up,v-matic hurst shifter,edelbrock performer nitrous, carter electric fuel pump,ignitor coil,solid motor mounts,magna racing suspension,poly urathane bushings,under rider traction bars, comp. eng. s

[kystang86]

mine did the same thing. try bleeding entire system and go from there. do the simple things first..

[HKstang]

Thanks for the replies guys. I've been pretty sick so I haven't had time to respond. I'm going to bleed the system and change my balljoints this weekend so hopefully that helps.