Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-06-2004, 11:37 AM
|
#1 |
|
Registered Member
Join Date: Jan 2004
Location: Newark, Delaware
Posts: 4
|
1968 DriveShaft/U joints
How do I remove the drive shaft? I need to replace the U joints and I know how to do that...but how do I get the shat itself out? After the center joint is undone, does it just pull out? Thanks.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Changing Ball Joints? | cschulzy | Windsor Power | 8 | 02-07-2004 09:58 PM |
| Ball Joints | cschulzy | Windsor Power | 4 | 03-23-2003 01:18 PM |
| Ball Joints | gray ghost86 | Windsor Power | 4 | 06-06-2002 11:08 AM |
| separating ball joints and tie rod ends...best way? | 82 GT | Windsor Power | 8 | 02-22-2002 03:56 PM |
| putting 94-95 ball joints on to 89 a-arms | John Cummins | Windsor Power | 0 | 06-18-2001 07:28 PM |