Wheel Bearing install

[PeTr0]

does the outer bearing go back into the hub with the larger diameter side first or last. I thought it was first but one side doesnt fit. If you guys can understand my question i would apreciate a quick answer.

------------------
Red 1993 Gt- 3.55 gears,flowmasters,BBK Shortie Headers, BBK Hi-Flow H-Pipe, BBK cold air induction w/K&N, Pro 5.0 shifer, 130 amp alt., underdrives,65mm T-body,MSD 6AL and blaster tfi coil sony cd player and changer, kicker component speakers, Kenwood Excelon amp, 2 12" subs in the hatch,firehawk sz50 all around, timing bumped to 13 deg., ADS Superchip, and mobil 1 oil lubing the 302.
waiting to be installed: 190 lph fuel pump

[elmir50]

The bearing is tapered. The side that is smailler in diameter goes in first. Remeber to torque the castle nut to spec and then back it off. While tightening the castle nut spin the rotor, make sure it spins freely when finished. You wanna torque the nut initially to ensure that the bearing is seated properly.