Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-01-2005, 07:04 PM
|
#1 |
|
Registered Member
Join Date: Apr 2004
Location: Tecumseh
Posts: 165
|
High Reving?
Hey guys,
Okay here is my question. I just rebuilt a 5.0 ho motor i put svo heads on it, roller rockers, stock intake and E303 cam. The problem is when i started it it reved fine at first at low idel, then it High reved as it was going in to the warming up stage, reving at 1500 rpms, and it never went down, it stays there, What may be the problem?
__________________
1988 mustang gt t-top svo alum. Heads, comp cam rockers, e303 cam, Mass air, BBK cold air induction, BBK throttle body, gt-40 intake 1 inch spacer, Alum. drive shaft, world class 5 speed, 3.55 gear rear end, drag front springs. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| Low, loppy idle then too high, then low again.... | Fox Body | Windsor Power | 6 | 08-05-2003 11:29 PM |
| high rise manifold | fordkid68 | Classic Mustangs | 2 | 05-18-2003 01:38 AM |
| 306 street fighter from Coast High. short-block | yelowjaket | Windsor Power | 2 | 05-15-2003 06:02 PM |
| High Reving Upon Startup | D&R Stang | Windsor Power | 8 | 06-03-2001 11:43 AM |