Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-28-2005, 11:50 PM
|
#1 |
|
Registered Member
Join Date: Mar 2005
Posts: 22
|
wheel studs
i recently bought a pair of draglites 15X8 with 5 1/2 in. backspacing for the rear.
i went to test fit them and the studs where too short to put them on  . i was wondering if you guy have any suggestions on who makes studs that would be long enough.
__________________
90 5.0 GT BBK full legnth headers BBK h-pipe Borla mufflers to dump off Auburn 28 spline rear diff. K&N conical filter C&L 76mm elbow BBK 75mm throttle body MSD distributer Edelbrock performer RPM II 3.73 gears |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| wheel studs | Lightspeed | Classic Mustangs | 3 | 12-26-2002 01:59 PM |
| Wheel Studs Installation | glxstang | Windsor Power | 3 | 03-27-2002 08:13 AM |
| wheel studs are evil | father joe | Blue Oval Lounge | 1 | 02-27-2002 10:18 PM |
| Broken Wheel Studs... | AutoX281 | Modular Madness | 5 | 03-26-2001 03:00 PM |
| Wheel studs | MikeBlackGT | Windsor Power | 1 | 02-10-2001 01:01 PM |