manifold ?

[racobra]

i have a 1993 cobra was thinking about getting a new manifold as anbody now anything about the BBK SSI-series manifold good bad thanks for you time

[Ieatcamaros]

The magazines had a lot to say about that manifold. It made pretty good power in their tests. What's the rest of your setup?

[~The Jester~]

The magazines had a lot to say about that manifold. It made pretty good power in their tests. What's the rest of your setup?


YEP! An engine is a "system" or more specifically, an air pump. Throwing an intake at it may or may not help. Give us some more particulars.......

[tmoss]

If your Cobra is not highly modded, the only thing you are likely to experience is a lighter wallet. If you like the looks better, that could be a reson to buy it, and it is not likely to hurt power based on it's only published dyno test.

[racobra]

the motor is still stock as 29000 miles on it just thinking about doing stuff do it .I was just wondering about the manifold .so on a stock motor its really not worth it then save the money for head work. the car has 3:55 gears cf dual fric clutch B&M ripper shifter ,subframe connectors, 4 point lower chassis brace, strut tower brace,hotchkis lower and upper control arms, slotted rotors front and back,1 5/8 headers stainless ceramic coated, bassani stainless high flow cats and borla exhaust, ram air set up

[Ieatcamaros]

Spend your money on heads first.

[tmoss]

Yep, head work would be the best move - and if the heads wind up flowing more than 225cfm, get the Cobra lower intake ported - the stock Cobra intake flows 205-210cfm and can flow 250-260cfm with a pro-port job.