driveshaft looses

ffast69 · 04-23-2006, 12:57 PM

Hi, I loose the driveshat from my 69 mustang coupe (Don't ask

) It has 302 engine and C4 Automatic transmission

Please, I need to buy one, but i don't have the spec in order to request it or if any one can inform some place where can i get it.

Gearhead999 · 04-23-2006, 02:04 PM

In the states, here, you can usually find a used shaft. Or you can have one made at a driveshaft shop.

To find a used one I'd start with Classic Mustang Parts of Oklahoma 405-631-1400m www.ilovemymustang.com.

I've never used them, but they are always in Hemmings. Now shipping it to Chile without damaging it, well that's another story.

FYI, the last driveshaft I had made. The shop just wanted the measurement from the differential yoke to the outside edge of the rear transmission seal, measured with the car on the ground at ride height. I also told them what the spline count was on the front yoke and what u-joint was on the rear. Two days later I had a brand new shaft.

Hope this helps.

04-23-2006, 12:57 PM	#1
ffast69 stang69 Join Date: Apr 2006 Location: Chile Posts: 1	driveshaft looses Hi, I loose the driveshat from my 69 mustang coupe (Don't ask ) It has 302 engine and C4 Automatic transmission Please, I need to buy one, but i don't have the spec in order to request it or if any one can inform some place where can i get it.

04-23-2006, 02:04 PM	#2
Gearhead999 Registered Member Join Date: Sep 1998 Location: Oviedo, FL Posts: 992	Re: driveshaft looses In the states, here, you can usually find a used shaft. Or you can have one made at a driveshaft shop. To find a used one I'd start with Classic Mustang Parts of Oklahoma 405-631-1400m www.ilovemymustang.com. I've never used them, but they are always in Hemmings. Now shipping it to Chile without damaging it, well that's another story. FYI, the last driveshaft I had made. The shop just wanted the measurement from the differential yoke to the outside edge of the rear transmission seal, measured with the car on the ground at ride height. I also told them what the spline count was on the front yoke and what u-joint was on the rear. Two days later I had a brand new shaft. Hope this helps. __________________ "Support our Troops" Dave 1968 Cougar 2004 Thunderbird 2007 F150 Harley-Davidson, SuperCrew 1986 LTD 1997 Ranger 1992 Honda Civic

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Driveshaft or Rear-end	UglyFast88	Windsor Power	3	06-04-2003 07:16 PM
Aluminum Driveshaft ?s	89 Cobra LX	Windsor Power	3	07-15-2002 03:42 PM
Tremec in '95-Longer Driveshaft	95Convert	Windsor Power	1	07-22-2001 05:22 PM
New rear end, stock driveshaft???	BennyBoy	Windsor Power	5	07-02-2001 07:00 PM
U joints? or driveshaft?	Mustangbelle306	Windsor Power	6	05-14-2001 01:19 AM