View Full Version : bbk header
cbr900
03-24-2007, 06:06 PM
I just bought my first mustang..its a 94 gt..it has bbk headers on the passenger side theres a threaded tube from the header to the engine(EGR??)this keeps coming loose no matter how tight i get it..can I elimiante this or is there any tricks to keepin it tight?Thanks
USMC302
03-24-2007, 06:14 PM
If your not worried about emissions, then weld it shut and remove the smog pump crap. I did on a 95 and had no drivability probs or idle probs. Another route would be to put some thread locker on it, but good luck removing it when you need to next time.
cbr900
03-27-2007, 10:41 PM
Thanks...I got some of the blue loctite...so far its holding...appreciate it..
USMC302
03-28-2007, 11:49 AM
i think the red is the high temp stuff, if it comes loose again, try find it.
goodyear1984
03-30-2007, 10:33 PM
yea deff use the red when it comes off again...also if u get rid of all the bullshit and theres a egr elimanator that i got and it seems to work pretty good no check engine light
cbr900
03-30-2007, 10:41 PM
Where can I find the eleminator? What is all involved in deleting it? Will it prevent me from passing echeck? If so can I just put it back on whaen I need to test the car?Sorry Im a newbie just tryin to learn what i can..Thanks
Dark_5.0
04-02-2007, 06:05 PM
What is all involved in deleting it? Will it prevent me from passing echeck?
More than likely