Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-02-2009, 11:18 AM
|
#1 |
|
Registered Member
Join Date: Dec 2008
Posts: 4
|
12 volt source in start & crank position
I am doing a efi swap in my 1964 1/2 Mustang and I am having problems with finding a source that gives 12 volts in both the start and crank position.I was trying to use a ignition wire that was hooked up to a stereo but in the crank position it loses voltage. Would I maybe have to tap into the wire directly behind the key ignition switch?
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 12 volt battery | procharge94 | Windsor Power | 0 | 01-31-2008 10:36 PM |
| 95 GT will crank but wont start ...dam | Clayton | Windsor Power | 7 | 02-13-2006 08:36 AM |
| MAF tested with volt/ohm meter HELP! | BOW TIE SMASHER | Windsor Power | 6 | 10-28-2002 09:16 PM |
| Stock Crank or Eagle Crank?? | Jwade | Windsor Power | 4 | 02-01-2002 11:34 AM |
| Help! Car will crank but not start after swap | vangogh | Windsor Power | 1 | 03-22-2001 06:05 PM |