© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-02-2009, 11:18 AM | #1 |
Registered Member
Join Date: Dec 2008
Posts: 4
|
12 volt source in start & crank position
I am doing a efi swap in my 1964 1/2 Mustang and I am having problems with finding a source that gives 12 volts in both the start and crank position.I was trying to use a ignition wire that was hooked up to a stereo but in the crank position it loses voltage. Would I maybe have to tap into the wire directly behind the key ignition switch?
|
07-15-2009, 05:56 PM | #2 |
Registered Member
Join Date: Mar 2004
Location: Minnesota
Posts: 950
|
Re: 12 volt source in start & crank position
I would check around the starter solenoid, it's been awhile but I believe one of the prongs is hot in both.
__________________
Alex |
07-16-2009, 10:16 AM | #3 |
Registered Member
Join Date: Dec 2008
Posts: 4
|
Re: 12 volt source in start & crank position
ok thanks...
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
12 volt battery | procharge94 | Windsor Power | 0 | 01-31-2008 10:36 PM |
95 GT will crank but wont start ...dam | Clayton | Windsor Power | 7 | 02-13-2006 08:36 AM |
MAF tested with volt/ohm meter HELP! | BOW TIE SMASHER | Windsor Power | 6 | 10-28-2002 09:16 PM |
Stock Crank or Eagle Crank?? | Jwade | Windsor Power | 4 | 02-01-2002 11:34 AM |
Help! Car will crank but not start after swap | vangogh | Windsor Power | 1 | 03-22-2001 06:05 PM |