MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Classic Mustangs (http://forums.mustangworks.com/forumdisplay.php?f=10)
-   -   1965 Conv. Top Down Not Fitting? (http://forums.mustangworks.com/showthread.php?t=50502)

BARONYOUNGMAN 08-09-2008 02:50 PM
1965 Conv. Top Down Not Fitting?
 
It is a 1965 convertible mustang which I have welded in new wheelhouse inner panels and wheelhouse outer panels. I have pounded down the lips on the panels but my top will not go all the way down . IDEAS? The top is new, I didn't own the car before so I do not know if the top ever went down. Is the panels different between the coupe and convertible? Could someone post a pix of what it is suppose to look like?

Thanks
Bob

sixtysixgtconv 07-05-2009 09:19 PM
Re: 1965 Conv. Top Down Not Fitting?
 
Quote:
Originally Posted by BARONYOUNGMAN (Post 334014)
It is a 1965 convertible mustang which I have welded in new wheelhouse inner panels and wheelhouse outer panels. I have pounded down the lips on the panels but my top will not go all the way down . IDEAS? The top is new, I didn't own the car before so I do not know if the top ever went down. Is the panels different between the coupe and convertible? Could someone post a pix of what it is suppose to look like?

Thanks
Bob
Move the top back from the windshied header about half way. This should reveal slack in the top(between the header and the second hinge(each side). Pull(lightly) out on the top in the area of the first hinge.This will allow the top to lay flat when stored. Paul


All times are GMT -5. The time now is 01:21 PM.