1966 Wire Wheel Covers
 

Just got my wire wheel covers today. My question is how do you install the spinner on the wheel and what is the other circular piece for? any input is greatly appreciated!! Thanks in advanced.

------------------
90 Mustang GT (hatchback)
3.55's, dyno-max exhaust,
Mac Cold Air Induction

anyone????

------------------
90 Mustang GT (hatchback)
3.55's, dyno-max exhaust,
Mac Cold Air Induction

no one?????????????

------------------
90 Mustang GT (hatchback)
3.55's, dyno-max exhaust,
Mac Cold Air Induction

Mustang, it seems that you might have contacted the vender or manufacturer to get an answer to this question. It shouldn't be that difficult. Try that avenue and then clue us all in.

Rev

------------------
'66 Coupe, 306, 300 HP, C-4, 13.97 e.t., 100.3 mph
1/4 mi.

I have never dealt with that paticular setup before. Is there any way you could scan some pics of all the different pieces so we could see what they look like? It'd be a place to start.

------------------
66 Tahoe Turquoise Coupe
Laser Red 96GT Ragtop
Both are slow but easy on the eyes!

OK ill give it a try, on my 65 i have the spinners so; The ring goes on the "inside"of the hub cap. so place it & mark the holes(hold it in place with tape) now drill the four holes the extra hole is for the alinement of the spinner. next,place the foam (if included)into the spinner& mate to outer side of hub cap,install the three screws (use loc-tite) now your done. NOTE: The inner ring is for keeping thespinner in balance, if you dont use them its gonna pass u by on the highway.trust me ive done it , Hope this helps. let me know.