© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-26-2000, 06:36 PM | #1 |
Registered Member
Join Date: Jun 1999
Location: North Haven,CT
Posts: 336
|
302 and a 5 spd
I realize this is a Mustang site, but I'll give it a shot. I have a 65 Falcon with a 6 and an C4. I was wondering if anyone cojld give me advise on a swap to a 302 and a T-5 5 speed out of a newer mustang (87-93). I have the V8 mounts, thats the easy part. However, I am lost when it comes to tranny mounts and clutch setup. Which clutch setup can I use? Will the T5 fit without too much hastle? Any help would be great. Thanks
|
04-26-2000, 10:03 PM | #2 |
Registered Member
Join Date: Jan 2000
Location: Concord,CA
Posts: 86
|
It should be the same as doing a mustang. You
can use the late model bellhouseing but you will need a new pivot for the clutch linkage, if you use the Z bar setup. If you use the early model bellhouseing you will need a adapter plate between the bellhousing and transmision. You can also use the cable clutch linkage that goes in the late model Mustang. I think Winsor Fox has the setup. www.windsor-fox.com Sinse you have a auto transmission now, useing the cable setup might be the way to go. If not you will have to locate a donor car with a manual trans to get the clutch linkage out of. Regards, BillGear |
Thread Tools | |
Display Modes | Rate This Thread |
|
|