MustangWorks.com : Ford Forums - View Single Post

E. Nix · 11-16-2001, 05:54 PM

I replaced the brake booster in a 70 Mach 1 I recently bought. When removing the old booster, I discovered that the connecting rod from the brake pedal into the booster had been ground down on the booster end so that it did not fit into the coupling in the booster and was "free floating" on that end. After completing the installation, the rod that attaches to the brake pedal is about 3/4 of an inch above the connecting point. If I force it down to the point of attachment, it is in too much of a bind to work. I am using the replacement pedal assembly used when converting brakes. The old pedal would bolt-up, but would be about 1 inch from the floor. I understand there may have been a couple of types of boosters used. There was a bendix on the car when I bought it and I replaced it with a bendix. Was there another type? Any other suggestions?

11-16-2001, 05:54 PM	#1
E. Nix Registered Member Join Date: Nov 2001 Posts: 1	70 Mach brake booster I replaced the brake booster in a 70 Mach 1 I recently bought. When removing the old booster, I discovered that the connecting rod from the brake pedal into the booster had been ground down on the booster end so that it did not fit into the coupling in the booster and was "free floating" on that end. After completing the installation, the rod that attaches to the brake pedal is about 3/4 of an inch above the connecting point. If I force it down to the point of attachment, it is in too much of a bind to work. I am using the replacement pedal assembly used when converting brakes. The old pedal would bolt-up, but would be about 1 inch from the floor. I understand there may have been a couple of types of boosters used. There was a bendix on the car when I bought it and I replaced it with a bendix. Was there another type? Any other suggestions?