Can you direct me to any articles that would show the location of the reenforcement materials on the upper control arms? I am using a wire feed welder and have done one lower arm afetr looking at a TCP boxed arm.
Thank you,
Lee
Quote:
Originally posted by thunderbolt:
I have seen this done in articles and also have some experience as a welder. It is pretty straight forward but if you want to try this your self just remember to make short welds and rotate around the piece you are working on so as not to build up too much heat in any one spot and cause warpage. That would be my biggest concern. Be careful too that you don't burn holes in the sheet metal. A mig welder would be the way to go on this.
|