Brake line question

H'YAMULE · 03-04-2001, 10:33 PM

Hi all, I am doing the grenada swap for my front brakes. Do I need an adapter for the lines or will everything fit without modifications? Thanks for any input.

induction · 03-06-2001, 07:05 PM

what line are you refering too? are you changeing the master cyyender too? if you add the proportioning valve than yes, you also must add thedistribution block in line.add the stainless line to thebottom port of the master to thethe new three way blockthen connect (l) & (r) front original lines to the block.now add the rear line to the porp line block an thats it . Hope this helps.

leestanger · 03-19-2001, 11:58 AM

You will also need a correct size fitting from your master cylinder to match with your exisitng lines. Ask for it at at Mustang supply company like Mustangs Plus. They have Granada swap stuff. Be sure to keep the outer tie rod ends from the Granada to fit properly. Good luck. It's an easy swap otherwise.

03-04-2001, 10:33 PM	#1
H'YAMULE Registered Member Join Date: Nov 2000 Location: Willis, Texas Posts: 20	Brake line question Hi all, I am doing the grenada swap for my front brakes. Do I need an adapter for the lines or will everything fit without modifications? Thanks for any input.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
brake question	69mach351	Classic Mustangs	6	08-12-2002 10:10 PM
Hopefully Last Brake Line Question	Kisner	Classic Mustangs	1	03-18-2002 02:15 PM
Rear Brake Line Removal	Kisner	Classic Mustangs	2	03-13-2002 12:31 PM
Emergency brake cable question	82 GT	Windsor Power	1	07-16-2001 03:56 PM
Trans brake, line brake.......	dinomite	Windsor Power	1	04-17-2001 10:36 PM

03-06-2001, 07:05 PM	#2
induction The Brit! Join Date: Feb 2001 Location: Across the Pond! Posts: 694	what line are you refering too? are you changeing the master cyyender too? if you add the proportioning valve than yes, you also must add thedistribution block in line.add the stainless line to thebottom port of the master to thethe new three way blockthen connect (l) & (r) front original lines to the block.now add the rear line to the porp line block an thats it . Hope this helps.

03-19-2001, 11:58 AM	#3
leestanger Registered Member Join Date: Oct 2000 Location: Stone Mountain, GA, USA Posts: 7	You will also need a correct size fitting from your master cylinder to match with your exisitng lines. Ask for it at at Mustang supply company like Mustangs Plus. They have Granada swap stuff. Be sure to keep the outer tie rod ends from the Granada to fit properly. Good luck. It's an easy swap otherwise.