MustangWorks.com : Ford Forums - View Single Post - Can't get Distributor In-289-Need Help Bad!

tooncis · 02-19-2000, 10:46 PM

I removed the dist to install new manifold.
I cant get it to drop in over the oil pump rod! I put grease down into hole to hold pump
rod in the center set dist into hole & gears
than bumped the engine.(that usualy works).
Any suggestions?
Thanks!!!!

02-19-2000, 10:46 PM	#1
tooncis Registered Member Join Date: Jan 2000 Location: San Antonio Tx. USA Posts: 19	Can't get Distributor In-289-Need Help Bad! I removed the dist to install new manifold. I cant get it to drop in over the oil pump rod! I put grease down into hole to hold pump rod in the center set dist into hole & gears than bumped the engine.(that usualy works). Any suggestions? Thanks!!!!