MustangWorks.com : Ford Forums - View Single Post

Phillyfanfrombirth · 07-03-2006, 08:45 PM

If it worked just fine before you swapped out plugs, wires, cap, and rotor... my guess would be that something in there is the problem. Perhaps the wire going to the condensor is grounding out or maybe you have a couple wires crossed... maybe the gaps are off.

Don't touch anything else in the carb until you double check your tune up, especially if it ran fine before you did the other swaps.

07-03-2006, 08:45 PM	#2
Phillyfanfrombirth Registered Member Join Date: Dec 2004 Location: South Central PA Posts: 358	Re: carb wont work after rebuild If it worked just fine before you swapped out plugs, wires, cap, and rotor... my guess would be that something in there is the problem. Perhaps the wire going to the condensor is grounding out or maybe you have a couple wires crossed... maybe the gaps are off. Don't touch anything else in the carb until you double check your tune up, especially if it ran fine before you did the other swaps.