Clutch equalizer lever support for 66 coupe

66 Racer · 09-02-2002, 08:07 PM

Hey guys,

I have the other post about building the 289 or 302.

What i wanted to know was if any of you guys knew where i could buy a bracket to use on a later block that supports the clutch equalizer bar sicne ford dtoped incorperating this into the blocks in what i believe was 75. If you dont know of anyone who makes one, what other options do i have since i have a manual tranny, if going to a cable clutch kit, what is nessesary to do it properly.

Thanks

Anthony

John Z · 09-03-2002, 08:53 AM

This is a common issue and there is an adapter bracket. Check with your favorite Mustang parts supplier.

66 Racer · 09-14-2002, 06:40 PM

Thanks,

I hope california mustang has something

09-02-2002, 08:07 PM	#1
66 Racer Registered Member Join Date: Jul 2001 Location: West Covina, CA Posts: 77	Clutch equalizer lever support for 66 coupe Hey guys, I have the other post about building the 289 or 302. What i wanted to know was if any of you guys knew where i could buy a bracket to use on a later block that supports the clutch equalizer bar sicne ford dtoped incorperating this into the blocks in what i believe was 75. If you dont know of anyone who makes one, what other options do i have since i have a manual tranny, if going to a cable clutch kit, what is nessesary to do it properly. Thanks Anthony __________________ Under Construction 66 Coupe -289 V8 - 600cfm Holley -Tri-Y Headers - Flowmaster 2.5 dual exaust, Centerforce Dual Friction - Performer intake

09-03-2002, 08:53 AM	#2
John Z Registered Member Join Date: Feb 1999 Posts: 102	This is a common issue and there is an adapter bracket. Check with your favorite Mustang parts supplier. __________________ 68 coupe, 302 w/ Edelbrock performance parts, T5, 3.55 rear, needs paint!

09-14-2002, 06:40 PM	#3
66 Racer Registered Member Join Date: Jul 2001 Location: West Covina, CA Posts: 77	Thanks, I hope california mustang has something __________________ Under Construction 66 Coupe -289 V8 - 600cfm Holley -Tri-Y Headers - Flowmaster 2.5 dual exaust, Centerforce Dual Friction - Performer intake

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Clutch Release lever Spring Question	orlowted	Classic Mustangs	2	12-22-2003 06:32 PM
Loud "pop" after clutch install, won't go into gear..	Chris_H	Windsor Power	3	08-11-2003 06:24 PM
T-5 swap & cable clutch problem	LuvMyStang	Classic Mustangs	0	03-19-2003 08:47 AM
'65 Mustang - Pull Away Problems	geordie	Classic Mustangs	6	05-11-2002 04:46 PM
billed 5 times to install clutch by Pauls Auto, please read and give opinions (long)	beefcake	Blue Oval Lounge	2	02-23-2001 03:05 PM