I'm confused? This is an intake manifold, right? These low pressures (negagative) should allow repair with J&B Weld or equivalent. If it's a head your'e talking about, it can still be welded, but by an expert welder of aluminum alloy. Find one in your area.
Rev
------------------
'66 Coupe, 306, windage
tray, TRW flat tops, 351W
heads,pocket ported, 268
CC hydraulic cam, R tip
R's, Edelbrock Performer,
600 CFM Holley vac. secs.,
Mallory Unilite, coil, fuel
pump, Tri-Y headers, 2 1/2 "
custom pipes, 3 chamber
Flows, stock C-4, 3.25
Currie built 8" rear
and whatever else I
forgot. 14.17 e.t., 97 mph
1/4 mi.
|