

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: May 2002
Location: Fresno, CA.
Posts: 10
|
![]() Thanks for the help so far.
Readjusted the valves to finger tight plus 1/2 turn. I probably need to replace my rockers. (None in Fresno. Just the rail type) Replaced my PVC. Took off my demon Carb and put on the Edlebrock. Car running much better. Idles between 600/700 rpm. Timing back to 5btdc. Had it 10/12/14 etc. Poor low end performance and with the edlebrock the top end is weak. Still working on it. I think I may have jumped a tooth on the timing chain. |
![]() |
![]() |
![]() |
#2 |
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
![]() Run a compression check.
Take care, -Chris
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Please help stutering problem | Just me | Windsor Power | 10 | 10-18-2002 02:37 PM |
Intermitant engine problems...NEED HELP! (long) | blueneonman1 | Windsor Power | 4 | 05-19-2002 10:57 PM |
Engine shake problem? | chris91LX | Windsor Power | 1 | 05-19-2002 05:31 PM |
Engine Build Update | Fostang | Stang Stories | 1 | 02-15-2001 08:52 AM |