© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-28-2007, 07:45 PM | #1 |
Registered Member
Join Date: Aug 2007
Location: ontario
Posts: 19
|
fel pro gasket problem
i purchased a fel pro gasket set for my 289 v8, as per the intake manifold gaskets, it doesn't state on the gasket or in the instructions, as to which side the extrusion bump goes! towards the head or towards the intake?
please help |
09-27-2007, 03:21 AM | #2 |
Registered Member
Join Date: Jun 2000
Location: ventura,CA
Posts: 438
|
Re: fel pro gasket problem
Extrusion bump? Are you talking about the intake manifold gasket or the gaskets that seal the ends of the intake to the block?
__________________
92 GT, 4:10 gears, centerforce clutch, 6# powerdyne blower, bbk h-pipe, flowmasters 65 Mustang 13.50 107mph 3000' ALt. 65 Falcon Straight Axle Drag Car |
09-29-2007, 05:33 AM | #3 |
Registered Member
Join Date: Aug 2007
Location: ontario
Posts: 19
|
Re: fel pro gasket problem
there are small " L " shaped bumps embossed into the manifold gaskets, does the bump go against the head or the intake manifold?
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
TB / EGR gasket Q | drudis | Windsor Power | 1 | 02-14-2002 10:49 PM |
Oil Pan Gasket | Elvis | Classic Mustangs | 8 | 11-18-2001 12:57 AM |
TB Gasket?? | 95mustanggt | Windsor Power | 6 | 08-30-2001 01:25 PM |
Gasket #'s | Shotgun28 | Windsor Power | 1 | 06-01-2001 12:39 PM |
Mr. Gasket or Fel-Pro | 92Rustang | Windsor Power | 2 | 04-10-2001 06:15 PM |