horn problems
 

hello everyone this is my first post. I am having a problem with the horn on my 1966 mustang. every time I make a turn it honks, I have replaced the harness two times and i continue to have this problem. any Ideas on what else I can do?

Re: horn problems
 

It may be the contacts in the horn ring, or the horn ring may be loose.

Re: horn problems
 

thanks but I have checked that and it all looks good. I should also mention that I had to replace the steering wheel. ever since I did that I started with this problem. I was told that maybe i should pull the steering out a little, but Iam a little hesitant to do that.

Re: horn problems
 

Did you replace the harness before or after the steering wheel?

Re: horn problems
 

Did you install the spring when you changed the steering wheel??

Re: horn problems
 

yes I had installed the harness on before replaceing the steering wheel. I did install the spring on the steering wheel when I installed the new one.

Re: horn problems
 

What I eventually had to do on my '66 was to use the horn lead as a signal to a "new horn relay" that activated my new auto supply horn. Not exactly concourse correct, but it works perfectly and is very loud.

Rev

Re: horn problems
 

my 61 galaxie had that problem the ring was shot/bent and i changed the spring..also idk if its the same set up but there was these little tabs that hold and lock in the horn to the streeing wheel if thoes are brok it may cause that too