Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-27-2001, 12:48 PM
|
#1 |
|
Registered Member
Join Date: Feb 2001
Location: Brandon, Manitoba, Canada
Posts: 11
|
cam break-in PROBLEMS
I put an '80 351W into my 68 mustang. I first installed an Edelbrock Performer cam, timing chain and gears and Performer intake.This morning was the 30 min. initial start-up to break in the cam. I turned it over first to build up some oil pressure, then started it on high idle. She purred like a kitten. About 5 minutes into the run there was some random clunking and the engine started running a little rougher. There was a few more occasional clunks and after a couple of louder ones I shut it down at the 15min. mark. I followed the installation instrucions to a tee. Did I knock a lobe off? Any suggestions what to check now? Murray
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| what if any problems with your Modular Model Gt/Cobra? | fixer | Modular Madness | 18 | 04-03-2005 09:18 AM |
| HELP: Problems after Paxton Novi 1000 install | Meatman | Windsor Power | 3 | 10-17-2002 06:03 PM |
| Sick 88 Gt Computer problems? | ziggy_2k | Windsor Power | 5 | 06-02-2002 10:33 PM |
| '65 - Pull Away Problems - Action Plan | geordie | Classic Mustangs | 0 | 05-14-2002 01:43 PM |
| Long weekend...car problems | silver_pilate | Blue Oval Lounge | 4 | 04-15-2002 12:12 PM |