© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-08-2004, 09:31 PM | #1 |
Registered Member
Join Date: Jan 2002
Posts: 100
|
Need help from someone with a groundpounder k member
I installed a ground pounder K member on my mustang. I can't get it lined up. One wheel is farther forward than the other. The engine tilts too one side, and the engine is about an inch too far back because my driveshaft will not fit anymore. I have the motor sitting in the first slot. I ma not using the 1" back slot on the k member. I need to see if this is normal or do I have another problem.
|
04-10-2004, 10:55 PM | #2 |
Registered Member
Join Date: Feb 1999
Location: Indianapolis, IN
Posts: 963
|
Something is wrong. Are you sure you have your motor mounts on the right sides? Can you post pics? You should not have to alter your ds. You said you were in indy, if so where maybe I can come over and take a look at it.
__________________
04 Screamin Yellow Cobra KB 2.4 (585/556 pump 626/666 race) 00R brakes, DFX clutch, Level 5's, return fuel system, Lts with 3" exhuast, FR500 wheels and all the other fun stuff. GONE 1991 Lx sedan 5.0, 5spd (Liberty proshifted TKO) S-trim, Ported TF heads everything parted out. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
K Member | 65,dohc,project | Classic Mustangs | 0 | 10-06-2004 03:27 PM |
Fallen Member of the SVT Family...on Sept. 11 (long) | NO SLO PK | Blue Oval Lounge | 6 | 10-20-2001 01:28 PM |