© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
04-27-2001, 04:42 PM | #1 |
Registered Member
Join Date: Feb 1999
Location: Utica, Michigan
Posts: 2,631
|
Changing valve seals
Is there any trick to doing this on the car?
I was going to remove the rockers, fill the cylinder with air, remove the springs, then the seals should pry right out right? Thanks, Rob |
04-27-2001, 05:15 PM | #2 |
Guest
Posts: n/a
|
I think that just about covers it.
Do you think the seals are causing your slight smoking prob? ------------------ 91 coupe 3.73's,long tubes,2 1/2" exh,ported stock t-body,ProM-77mm cobra intake,edelbrock heads,B303,1.72 rr's 36lb inj's,tremec, & a Paxton NOVI 2000!!! 11.020 @128.95 on BFG Drag Radials (275/60/15) |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Valve seals too tight? | Hozer 88GTConv | Windsor Power | 0 | 03-09-2004 02:55 PM |
valve seals | rtschoneman | Classic Mustangs | 1 | 03-15-2003 04:19 PM |
changing valve cover gaskets | HP400RW | Windsor Power | 7 | 01-20-2003 12:56 PM |
valve seals | 89GTAtcoRaceway | Windsor Power | 1 | 03-28-2002 09:04 PM |
Valve guide seals? | Shotgun28 | Windsor Power | 1 | 03-13-2001 11:48 PM |