Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-26-2003, 01:13 PM
|
#1 |
|
Registered Member
Join Date: Dec 2002
Location: Biloxi.Mississippi
Posts: 49
|
B&M Ripper Shifter ?
I have a Ripper shifter installed on my 95 GT(tremec).My question is on installation.When installing the shifter you have off-set washers that position the entire shifter up towards the engine or back towards the output shaft a slight bit.What is the purpose of this off-set?What is it's function?Does it matter what position you choose as far as shifter operation goes?I am having trouble downshifting after the install.Down shifted fine with the stock tremec shifter.Any input on this would be greatly appreciated.Thanks 95/GT/5.0
__________________
1995/GT/5.0 |
|
|
|
09-26-2003, 01:25 PM
|
#2 |
|
Registered Member
Join Date: Dec 2002
Location: Biloxi.Mississippi
Posts: 49
|
1
__________________
1995/GT/5.0 Last edited by 95/GT/5.0; 09-26-2003 at 01:54 PM.. |
|
|
|
|
09-26-2003, 01:52 PM
|
#3 |
|
Registered Member
Join Date: Dec 2002
Location: Biloxi.Mississippi
Posts: 49
|
Better pic
__________________
1995/GT/5.0 |
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| B&M Mega Shifter.. | 71grande | Classic Mustangs | 3 | 01-10-2006 04:56 PM |
| Anyone ever install a B&M hammer shifter in there AODE 4.6 GT?? | 96_4.6 | Modular Madness | 15 | 08-24-2003 12:43 AM |
| B&M ripper shifter? | stang_guy_95 | Windsor Power | 2 | 03-23-2003 11:43 PM |
| B&M Ripper vs. Kirban Kwik Shifter | DEPete | Special Production | 1 | 03-30-2002 08:10 PM |
| B&M Ripper vs. Kirban Kwik Shifter | DEPete | Modular Madness | 4 | 01-17-2002 12:20 PM |