power steering problem

speedie66 · 07-25-2000, 11:25 PM

I am rebuilding my ballstud (the unit behind the control valve) but on my 66 the manuals say it is supposed to screw on but on mine it doesnt.. does anyone else know if this is true or not.. I need a definite answer

------------------
66 mustang 289x.30 over, holley 600 cfm carb,c4 trans,rebuilt engine, 270+ hp

Gearhead999 · 07-29-2000, 06:22 AM

The ball stud should have a taper and threaded with a cotter pin hole. You install it from the inside and push it through.

What do you have ??

07-25-2000, 11:25 PM	#1
speedie66 Registered Member Join Date: Jun 2000 Location: glendale arizona Posts: 22	power steering problem I am rebuilding my ballstud (the unit behind the control valve) but on my 66 the manuals say it is supposed to screw on but on mine it doesnt.. does anyone else know if this is true or not.. I need a definite answer ------------------ 66 mustang 289x.30 over, holley 600 cfm carb,c4 trans,rebuilt engine, 270+ hp

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
power steering hose re-route for headers	tfish	Classic Mustangs	0	08-30-2003 01:05 AM
bypass power steering?	madmav71	Classic Mustangs	1	07-10-2003 11:44 AM
Power Steering Whine	MidNiteBlu 5.0	Windsor Power	6	06-26-2002 02:00 PM
Power Steering Pump Bleeding?	oamunoz	Classic Mustangs	2	09-30-2001 05:41 PM
Power Steering Frustration!	MidniteWrider	Classic Mustangs	2	08-13-2001 11:10 AM

07-29-2000, 06:22 AM	#2
Gearhead999 Registered Member Join Date: Sep 1998 Location: Oviedo, FL Posts: 992	The ball stud should have a taper and threaded with a cotter pin hole. You install it from the inside and push it through. What do you have ??