Pressure plate install, quick question

bmxmon · 06-02-2004, 09:26 AM

which way is the pressure plate supposed to go in? I forgot to take note of which way it came out. Right now, i have it in so that the side that sticks out a bit from the center of the plate than the other side will be pointing towards the tranny. Is this right?

Lou Lyman · 06-02-2004, 03:44 PM

Must be talking about the clutch disc. That sounds right. Pressure plate only bolts on one way.

Lou

06-02-2004, 09:26 AM	#1
bmxmon Registered Member Join Date: Mar 2004 Location: Minnesota Posts: 950	Pressure plate install, quick question which way is the pressure plate supposed to go in? I forgot to take note of which way it came out. Right now, i have it in so that the side that sticks out a bit from the center of the plate than the other side will be pointing towards the tranny. Is this right?

06-02-2004, 03:44 PM	#2
Lou Lyman Registered Member Join Date: Dec 1998 Location: Tampa, FL Posts: 70	Must be talking about the clutch disc. That sounds right. Pressure plate only bolts on one way. Lou __________________ Enjoy what you do. Do what you enjoy.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
MSD 6BTM Install Question	p51302	Power Adders	1	05-31-2004 08:21 AM
Fuel pressure question?	BOW TIE SMASHER	Windsor Power	1	11-21-2002 01:38 AM
oil pressure install question??	boricua_5litro	Windsor Power	2	03-18-2001 05:45 PM
trans temp, oil pressure gauges, install questions....	88COBRA	Windsor Power	6	02-01-2001 12:38 PM
Do I need to use pressure plate alignment dowels with clutch install?	TROYXTROY	Windsor Power	4	01-25-2001 02:12 PM