1967 Frame Dimensions
 

The Mustang and Fords March 2002 issue contained a technical article titled “Getting it Straight”. The article included plan view and side view of a 65-66 mustang unit body and provided numerous fixed reference points and the dimensions between them to determine if the body alignment correct. Prior to welding subframe connectors and torque boxes into my 67 coupe I would like to verify my car does not need to taken to the frame shop. Where can I find the unit body dimensions for a 67 that may be used determine if the body is straight?

Re: 1967 Frame Dimensions
 

I don't know if you have a 67 shop manual or not, but the dimensions for my 68 are in my shop manual.

Same for me
 

Same for me. The frame demensions for my '66 are right there in my Ford shop manual.

rev

Re: 1967 Frame Dimensions
 

Ok, I pulled out my Haynes manual and verified there are no frame dimensions listed. The Ford manual appears to have more information. Could someone with a scanner please post or email me directly the page or pages containing the dimensions for a 67 coupe. Thanks in advance.

Re: 1967 Frame Dimensions
 

if you want a scanned copy of the dimensions let me know i have a body shop book with the mustang fram dimension in it and picture showing where they measure what from. other optin is go to a chilton book versus Haynes they have the dimension in almost everyone of the chiltons i have seen ( in body section ) i also remember some parts catalogs have a quick refernce picture of dimensions but i cant remember which one it was i had that has it, i will look later

Re: 1967 Frame Dimensions
 

can i please get a scanned copy of the frame dimensions for a 1967 ford mustang. any measurement or any of the the front part would be good. if there is none for 67 a 66 or 68 would be okay. does anyone know if they are the same. please e-mail it to me asap. thanks in advance.

Ken

klam114@yahoo.com

Re: 1967 Frame Dimensions
 

http://forums.mustangworks.com/showt...ame+dimensions

That is how I found this forum... did a search on the dimensions.

Re: 1967 Frame Dimensions
 

The one mistake that I made when i replaced the frame rails, floors, and front end, was that I didn't take a measurement from the front to back. It aligned alright, but the wheelbase is about 3/8" short...