12 volt source in start & crank position
 

I am doing a efi swap in my 1964 1/2 Mustang and I am having problems with finding a source that gives 12 volts in both the start and crank position.I was trying to use a ignition wire that was hooked up to a stereo but in the crank position it loses voltage. Would I maybe have to tap into the wire directly behind the key ignition switch?

Re: 12 volt source in start & crank position
 

I would check around the starter solenoid, it's been awhile but I believe one of the prongs is hot in both.

Re: 12 volt source in start & crank position
 

ok thanks...