Performance mounts - 70 Mach I Windsor
 

I'm looking for performance motor mounts to fit a 70 Mach I with a 351 Windsor, preferably polyurethane. Thanks.

[This message has been edited by Trey Ragsdale (edited 01-21-2001).]

Don't believe I have ever seen a polyurethane mount. I gather that you are trying to keep the motor from rolling on launch? I run stock mounts but have a torque strap installed. No movement what so ever.

Ron

You can get solid mounts, but you won't like the vibration in a street driven car.

Rev

------------------
'66 Coupe, 306, 300 HP, C-4, 13.97 e.t., 100.3 mph
1/4 mi.

Good advise given above - I have used a torque strap with stock mounts (in good condition) in the past, with great success. Rev is absolutely correct that if you drive the car with any frequency on the street the vibration from solid mounts will drive you nuts after a while - I used them in a past project car and took them out after two weeks and went with the stock mounts and strap setup.