Ok, heres everydetail...
1968 Mustang Coupe Sound deadening removed.
Brand new FMS crate motor.
Y302 Aluminum heads
E-303 Cam
Edelbrock performer 289 intake
600cfm holley carb (Box stock)
Full Length headers with H-pipe back to 2chambers flows. 2" pipe all the way out to the back.
Stock c4 tranny.
3.08 gears
Petronix Ignition
stock 7mm wires
stock pulleys
vacume advance
Edelbrock water pump
paper air filter
195 thermostat
Stock clutch less bolt on fan
Timing ?? Somewhere from 10-15degrees
It has good midrange power, but it just doesnt have nearly the top end pull of my 5.0. From 4000-5500rpm its just the same power, its loud, but it doesnt pull hard!
I know it has bad gears, but it should pull hard on the topend, and it doesnt.
Skyler
------------------
1989 Saleen Mustang #406
-----------------------
TFS Heads, Edelbrock intake, E-303, 3.73's, 1 5/8 shorty headers, Offroad-Hpipe, 2chamber flows, 36psi FPR, 32deg timing w/ spout out, 70mm tb, 73mm maf, 24lb injectors, K/N, March Crank pulley, MSD6a, 9mm wires and FMS Aluminum driveshaft.
Best ET 13.2@106mph (untuned)
Gtech 14.1@112mph
|