Santa came early
 

http://www.fordmuscle.com/pictures/v...%201%20209.jpg

I wasn't expecting them until tomorrow. They are beautiful! 210cc /2.02/1.60/60cc. I also like my new valve covers. I was going to buy a 351 W locally but decided against it since I was unsure of the internal parts being what the owner claimed they were. What are they going on you ask. If you read my earlier posts you know that I have stock pistons. Well, I also bought a 347 stroker! I won it on e-bay. It pushed 512HP with 10psi boost. Of course I don't get the supercharger. He has every receipt for the engine from every nut to every bolt. The engine was built by a professional. I seen the car on the dyno on the engine builder's web site. He was running 8.5:1 with
64cc heads. With my 60cc heads should my compression be?

400 miles on 347 stroked motor after build. He ran the 95 GT into a ditch and parted it out.

- PBM Scat Forged Crankshaft - $551.83

- PBM Connecting Rods - $385.19

- JE Dished Pistons - $578.32

- JE Piston Ring Set - $69.50

- Lunati Hydroauic Roller Camshaft 580 lift- $293.99

- Ford Racing Hydraulic Roller Lifters - $104.88

- ARP Internal Bolt Kit - $43.28

- Danabond Cam Bearings - $15.98

- HX Rod Bearings - $102.78

- ARP Main Studs - $56.32

- Ford Racing Timing Chain - $70.00

- Ford Racing Bearing Retainer - $45.00

- Professional Products Harmonic Damper & Spacer - $79.10

- Comp Cams Push Rods

- Center Force Throw Out Bearing - $30.30

- Flywheel

I'm sure I'm missing something but this is it. Will the clutch and pressure plate for a 95 model be the same spline pattern as the top loader 4 speed? Should I use the BBK underdrive pulleys that he has available? Or should I just bolt what I have on my 302 now?

http://www.fordmuscle.com/pictures/v...rt%20block.JPG
http://www.fordmuscle.com/pictures/v...t%20block3.JPG
_________________
Thanks!
Mike.

Re: Santa came early
 

yea bolt it up. if you break something you will know. but everything sould run great. congrats on the awsome present. wish i would have gotten it.

Re: Santa came early
 

He also has a Center Force Stage2 Clutch, Disc, & Pressure Plate that he'd sell me for $150. Is that a good deal. Only 400 miles on the set up. Will the clutch fit on the shaft of my toploader?