© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-28-2002, 02:16 PM | #1 |
Registered Member
Join Date: Aug 2002
Location: Dundee, OH
Posts: 3
|
Severe Clutch Noise and Resistence (ANYBODY?)
I have an 88 GT. I have recently put a new clutch and clutch cable in, and just the other day the clutch pedal became harder to press in, and has begun making a bad rubbing sound. The noise is coming from underneath the dash, and I don't think it has anything to do with the actual clutch. I'm wondering if anybody else has had a similar problem, and if anybody can tell me what they think may be the problem?
Last edited by jesys; 08-29-2002 at 12:44 PM.. |
08-28-2002, 02:40 PM | #2 |
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
I am having the same problem right now, I just installed a dual friction.
I did not add any extra grease to the bearing retainer or throwout bearing as suggested by the throwout bearing manufacter since it comes pre-greased. I should have done so and probably replaced the crappy aluminum retainer with a steel one. I am going to try and grease it with the tranny in the car. I will post my sucess or failure (probably the latter).
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
08-29-2002, 12:43 PM | #3 |
Registered Member
Join Date: Aug 2002
Location: Dundee, OH
Posts: 3
|
So nobody has any suggestions on this?
|
|
|