View Single Post
Old 12-02-2001, 02:04 PM   #1
gp001
Registered Member
 
gp001's Avatar
 
Join Date: Nov 2000
Location: So. Cal.
Posts: 244
Default Holley Carb question

I installed a new Holley 650(Dbl pumper, mech sec) on my car and set the float levels and idle. I drove the car for about 30 miles that day. The car sat for a few days, then I started it, warmed it up, and went on my way. At the first 2 stops it seemed fined, but at the third stop it began to idle irratically. I nursed it back home (where it stalled). I let it sit for a few hours, started it, and noticed "drips" of gas dripping off the booster venturis into the secondaries (both barrels). I rechecked the float level and even lowered , but it still drips.

Any ideas what would cause this??????????
__________________
347 CHP shortblock, TFS TW, Stealth, 650 Holley, Flowtech hdrs, Dr. Gas X, 2 Chmbr Flowmaster, MSD 6AL-Dist.& SS coil, March serpentine pulley system, Richmond 6 spd, CFDF, Hyd. TOB, Currie 9" w/3.50, alum Drv Shft, susp mods, TCP subframes & tower braces, Trans Am Racing power dual master, 4 wheel disc, 17x8 Torqthrust II's
Something up my sleeve
In a 66 coupe
www.2mfffabshop.com
gp001 is offline   Reply With Quote