Does anyone here have experience with the 351C?
I have recently aquired a 73 Mach 1 with a 351C.
It would seem, through extensive research, that the engine
in this car has been built close to Boss 351 specs.
Its a 4 bolt main block. 11-1+ compression ratio.
4v heads. Torker 351 high rise man. Crane Fireball 302A cam.
the list of parts goes on.
I, not having too much hands on wrench pulling, am a little
lost in how to make this car run a little better than it does.
Its runnning a little hot - my solution was to run a higher octane fuel mix, say 102? Timing?
Its a bit sluggish or boggy of the line. Timing? Stall Con?
Any advice to putting this baby back on the street / strip
would be appreciated.
I look forward to being a part of this Mustang Message Board!!!
Thanks,
brenT
