Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-16-2005, 06:23 PM
|
#1 |
|
Registered Member
Join Date: Jan 2005
Posts: 2
|
Engine Dies?
This weekend i tired to break in my cam, but about 30 seconds into the break-in the motor died so i started it back up and brought up the rpms and 20-30 seconds into the break-in the motor died again. Im a little lost on where to go from here. If you can please help me out, Thanks.
I had the balancer at 30 degrees before top dead center then i dropped the distributor in with it a touch advanced. my setup is: 351w: 10:8:1 compression Mighty Demon 750 carb Victor jr. intake Victor jr. heads comp cams hydraulic flat tappet: 250, 256 duration @ 50 degrees 554, 558 lift. MSD billet distributor (21 degrees mechanical advance) MSD 6a box MSD coil |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rare Mustangs....Got One? | 1969Mach1 | Blue Oval Lounge | 22 | 09-25-2010 04:59 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Classic Mustangs | 8 | 06-16-2005 11:43 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Small Ponies | 0 | 05-12-1999 02:27 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Racer's Club House | 0 | 05-12-1999 02:27 AM |