Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-22-2001, 08:29 PM
|
#1 |
|
Registered Member
Join Date: Jan 2000
Location: Concord,CA
Posts: 86
|
10 1/2 inch clutch problems!
I'm putting together a new engine/trans combo. I have a late model 302 with 10 1/2
inch motorsports clutch. I used the troughout bearing that came with the clutch kit. I'm running the stock z bar clutch linkage. With the adjustment all the way tight i only get about 2 inches of clutch movement. The clutch falls to floor, actually moving the clutch about the last 2 inches. Has anyone heard of this problem? Do i need a different troughout bearing or longer adjustment rod? Any thoughts? Regards, Billgear www.289mustang.com 1966 Mustang Coupe |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CLUTCH PROBLEMS (Fork??) | drewmp28 | Windsor Power | 6 | 07-18-2004 11:51 PM |
| '65 - Pull Away Problems - Action Plan | geordie | Classic Mustangs | 0 | 05-14-2002 01:43 PM |
| '65 Mustang - Pull Away Problems | geordie | Classic Mustangs | 6 | 05-11-2002 04:46 PM |
| Clutch Problems | blue302 | Windsor Power | 3 | 09-10-2001 01:37 PM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |